2023 Honda CBR650R.

Custom PPF, Detailing, Correction & Ceramic Coating.

We also offer a range of motorcycle detailing and protection services depending on your requirements. This near new 2023 Honda CBR650R received a custom detailing, paint correction, coating & PPF install package. At the customers request, we completed a full detail, 2 stage paint correction, ceramic coating, wheel coating & custom PPF wear pack.

Package Rundown.

Full Detailing & decontamination.
Clay Bar treatment to remove contamination.
Tar & road film removal.
2 Stages of Paint correction/ machine polishing. Moderate cutting stage to remove etching, stains and damage. Finishing stage to refine the paintwork and enhance gloss levels.
GTECHNIQ Crystal Serum Ultra installed on all fairings, tank and primary painted components.
GTECHNIQ Crystal Serum Ultra installed on miscellaneous areas including the engine, handlebars, levers, crash protection and where access was available.
CarPRO DLUX wheel coating installed on the wheels and plastic trim.
Shark helmet machine polished and ceramic coating with GTECHNIQ Crystal Serum Ultra.
Custom 3 piece PPF (Paint protection film) kit installed on the tank face and sides for scuff protection.

Package Rundown.

Full Detailing & decontamination.
Clay Bar treatment to remove contamination.
Tar & road film removal.
2 Stages of Paint correction/ machine polishing. Moderate cutting stage to remove etching, stains and damage. Finishing stage to refine the paintwork and enhance gloss levels.
GTECHNIQ Crystal Serum Ultra installed on all fairings, tank and primary painted components.
GTECHNIQ Crystal Serum Ultra installed on miscellaneous areas including the engine, handlebars, levers, crash protection and where access was available.
CarPRO DLUX wheel coating installed on the wheels and plastic trim.
Shark helmet machine polished and ceramic coating with GTECHNIQ Crystal Serum Ultra.
Custom 3 piece PPF (Paint protection film) kit installed on the tank face and sides for scuff protection.

Detailing.

The detailing stage is the first and most important step when it comes to cleaning and preparing the motorbike for paint correction and coating. All areas of the bike are thoroughly cleaned and detailed using a variety of chemicals, tools and equipment.

Detailing.

Decontamination.

The decontamination stage is carried out once the detailing stage is completed and the motorcycle has been thoroughly cleaned. An Iron fallout remover is used to chemically remove contaminants from all surfaces of the bike, followed by a clay bar to mechanically remove any harsher embedded contaminants.

Drying.

Once the detailing and decontamination stages are completed, we bring the motorcycle indoors and use a heated air blower to completely dry the bike. This ensures that no water is left on the bike that can run down when polishing.

Paint Correction.

This motorcycle received a 2 stage paint correction in order to achieve the best possible results and finish prior to installing the ceramic coating. The paintwork was covered in scratches, etching marks, imperfections and sun damage and required an initial cutting stage to remove the damage followed by a polishing stage to improve the gloss and clarity of the paintwork.

Ceramic Coating Install.

Once all prep work and paint correction is complete, the full bike is wiped down using an IPA prep spray to remove residues and oils from the surface. The coating is then installed and applied to cover every surface that is accessible by the coating applicator pad.

Wheel + Trim Coating install.

The wheels, plastic trims and other miscellaneous components are wiped down using an IPA cleaning agent. The CarPro DLUX coating is then installed and applied to cover every surface that is accessible by the coating applicator pad.

Custom PPF.

Custom PPF templates are created to map out the actual section to be covered. We created a custom 3 piece PPF kit to cover the face of the fuel tank & sides to prevent from abrasion damage whilst riding.